Paxton can eat shit.

3 cat buttholes. I love it.

How much purge for something like this?

I haven’t done that yet, but I would be interested.

Eric Johnson is a garbage person and that was immediately apparent when he got his panties in a wad because Clay Jenkins was doing the right thing and getting credit for it during the early days of the pandemic, and he just couldn’t stand not being the center of attention.

I need to attend some of these. Drafthouse is the only theater I’ve been to in almost 10 years and I enjoy a lot of their events. Older movies, and movie parties.

Unfortunately their buyer is Sony. But considering I might never have seen a movie in a theater again, I’m pretty happy about it the reopening.

HALLELUJAH! I need this.

This is extremely upsetting for me. I haven’t seen a movie in a different theater in maybe 10 years.

I think the thing that gives him the most anxiety is his crippling health issues.

I use Fusion 360 primarily but it is available in other CAD software, this is a decent description:

Timeline and Rollback: The timeline in Fusion 360 visually represents the design history, showcasing the sequence of features and operations. You can review, reorder, and modify design steps using the timeline. The rollback feature allows you to return to a specific point in the timeline and make edits, facilitating design iteration and exploration.

It has made working on interactive designs significantly easier for me, and saves a tremendous amount of time and effort.

Do they have editable history yet? That’s a big blocker for me jumping.

Good in east Dallas. We had a little power flicker which made me nervous but otherwise it’s just so damned cold.

Getting richer is very very easy when you are already filthy rich.

Man I wish I still loved baseball!

On my Prusa’s there is a pause command. The Artillery should be using Marlin (unless you flashed something else). Your slicer (Cura especially) will let you add a pause and even tell the machine where to park the head, that doesn’t use M600. I guess it depends on your firmware and the slicer you are using. It would easy to experiment with it. Put down a small test cube and add some pause commands and see what happens. I would use Cura or Prusa Slicer if you can as they both have pretty good support for the typical commands you would use on this.

When I make magnets on the printer. I create voids the shape of the magnet in the model near the bottom surface, then have the printer pause right before it the layer it is set to close the hole. Drop the magnets in and resume print. It will completely encase the magnet.

If you are up for suggestions. I would swap filaments at the layer after the base is finished and switch colors so that the logo will pop against the base color.

What a shithead. He’s been a garbage mayor. I can’t believe he ran unopposed.

I mean you can make a post saying you are looking for band members. I don’t think I would call it an ad. Go ahead and if it is bad we’ll let you know.