Lie? On the internet? Who would do that?!

I used to like the a400, had a few of them in service, but a few years ago I tried another one and it was terrible. Just… Slow… like an HDD. I did some research and apparently they changed something with the nand somewhere along the line. Did a bait and switch. I don’t remember the details but it annoyed me.

I actually needed to buy a budget SSD just today, and I got a BX500. We’ll see how it goes. I know not to expect much from a drive without DRAM, but at least I know that going in.

Thanks!

This is very informative thanks. I’ve printed a lot of PLA on my Creality glass plate with no issues, but I recently started with PETG and it’s insane how much harder it sticks.

I learned through trial and error to only remove it while the bed is still hot, but even then it really sticks too well.

Is this legit? Or are you making a spaghetti joke? I actually can’t tell lol