Looks like they are using it to warm the screen adhesive so they can remove the screen and repair the phone.

Sega worked with Microsoft a bit on the Dreamcast and tried to get Microsoft to offer backwards compatibility for the Dreamcast on the Xbox. It kind of makes you wonder if Microsoft copied Sega’s controller.

Old Sega consoles like that probably need their electrolytic capacitors replaced. I’d say like 80% of non-working Sega consoles I’ve had just needed the caps replaced.

I’m no fence installer or anything so I don’t know if it’s possible, but instead of replacing the fence, could the chain link part be removed from the posts and flipped over and reinstalled?

Make sure you’re buying 14/2 or 12/2 that has a ground wire and running that back to the breaker box. I saw the job you did with the big cable in the floor and it didn’t look like you ran a new cable that had a ground wire. It’s best to replace the old shoddy stuff with circuits that are up to code, even if you’re doing it DIY and your area doesn’t require homeowners to get it inspected. The codes are designed to prevent fires and loss of life.

You can mark it either red or black, but you already have one black wire, so it would be best to mark it red, just to differentiate it.

Since you went with 10/2 for a 240v outlet that means your cable will have two hots and a single ground. But the cable you bought will have a black, white and bare/green wire. Make sure that you wrap both ends of the white conductor with red electrical tape to indicate that it is also a hot wire. White normally indicates a neutral, but since you won’t have a neutral wire in this cable, it’s important to mark it. Otherwise someone else may work on this outlet in the future, see a white wire, assume it’s a neutral, wire something up with it as a neutral, and give themselves a pretty bad shock.

If you’re in North America, which I assume you are based on the 120v wires, then your assumption about 240v power is a bit off. Both wires can be a hot (120v) wire, 180° out of phase from each other, so they add to 240v. In this case, a neutral wire isn’t necessary to carry the current back, the other hot wire does that. A neutral wire may be used, but then there would be 4 wires.

The ground wire and the neutral wire actually connect to each other in the panel, but it’s not safe to use a ground wire in place of a neutral, so definitely don’t wire it to the neutral on the outlet.

If you are unsure of what’s going on with this set of wires, you should really call an electrician to help. Wiring a standard 120v outlet is something a homeowner can do, but identifying an old 240v cable on a dubious circuit is definitely something a qualified electrician should do.

The model doesn’t really matter. The Japanese ones tend to be a bit easier to get for a good deal.

I use mine for an Action Reply (basically a Game Shark) and it lets me play North American games on my Japanese console.

Not every package that comes with xfce has a name that starts with xfce4, just most of them do. You may need to identify and remove other packages too.

I think that: sudo apt purge xfce4* sudo apt autoremove

should do it.

I’ll point out that the other answers here are also correct. It depends on how you want to clean it from your system.

“apt remove” will only remove the packages, not the config files
“apt purge” will remove the packages and config files
“apt autoremove” will clean up the orphaned dependencies
“xfce4” will only remove the DE
“xfce4*” will remove the DE and most of the other packages that come with xfce

I use PETG on a PEI sheet like OP has. It will stick so hard that it rips the PEI off of the metal plate if I don’t put some hairspray down as layer in between.