Hey guys I got the bambu P1S a couple months ago because it was recommended. I’m super new to 3d printing. This is my first one. I’m not new to electronics or computers. I ran a few of the built in prints, a dinosaur puzzle and this scraping tool but both came out fuzzy and in poor build shape. What can cause this? Shaky table? Cold temps (the printer is in my insulated garage getting around 65 degrees at the moment inside)? Is the stock bed bad? The filament it came with bad?

Thanks for any advice.

  • mihnt@lemmy.caEnglish
    2·
    6 months ago

    Kept forgetting to tell you, you will want this for your ams and I use these for dryboxes. You can just grab some totes from the dollar tree or somewhere cheap and throw those in with the filament. Quick and easy way to keep your filament dry.

    Here’s a hygrometer stand of the same type so you can keep it uniform.

    Fill them with this stuff here.

    Make sure it’s the rechargeable kind so you can just keep redrying it and you’ll never run out.

    This is all especially important if you plan on printing PETG. PETG is affected much more by moisture than PLA.

    • Aermis@lemmy.worldOPEnglish
      2·
      6 months ago

      Wow I would have went through so much trouble trying to figure out my problems before stumbling on moisture problems. Especially since I’m printing in my garage.

      Thank you so much for bringing this to my attention before I ran into many problems. I didn’t even think about how I’m going to store all my filament. I was just going to go loose on the bottom of my table in a container.

      It’s interesting that the instructions for preparing the AMS had me take out the dessicant from the 2 trays in the roller area. I was wondering what the point of these being empty was. I’ll fill that with back up with dessicant.